Trail Bikes 132cc Big Bore Kit + VM26 Carb + Big Valve - CRF110

Trail Bikes 132cc Big Bore Kit + VM26 Carb + Big Valve Kit - Honda CRF110 2013-19 Models Only

This kit is one of the most complete performance kits for the 2013 thru 2018 CRF110.
It is the TB 132cc big bore kit combined with the race proven Mikuni VM26 carb kit and to top it off with a Big Valve Kit.
The combination of these 3 kits delivers the ultimate performance upgrade for your 2013-18 Honda CRF110!

Key features:
     -Fits 2013-18 Honda CRF110 (Not for the later fuel injected models)
     -Largest bore (55mm) you can go without boring the cases
     -Proven high quality Mikuni VM26 carburetor
     -New reverse intake manifold
     -Better cylinder head flow
     -Rev higher and faster with lighter valves
     -Oversized and higher quality valves over stock valves
     -More power and fun at an very affordable price

Kit includes:
     -55mm Aluminum Cylinder with Steel Sleeve
     -55mm Lightweight Piston & Rings with 13mm Wrist Pin
     -55mm Top End Gasket Set
     -Genuine Mikuni VM26mm Performance Carb (Not a cheap online fake)
     -Jet kit with 3 extra different sized jets
     -Reverse Intake Manifold Kit with Mounting Hardware
     -Foam Pod Air Filter
     -Throttle Cable (Straight for Stock 110 throttle or CR "Style" (If you need a billet Fast50s throttle you also want part # Throttlecable1826 )
     -Stainless Steel EV8 lightweight Big Valve Kit with valve springs, retainers, seals, and cotters.

Please note: The stock CRF110 throttle is restrictive and will need to be replaced w/ a CR "Style" Throttle or the TB Billet throttles. If you don't have one, we have a few throttles available that will work (BTA23000 or the FF1051TB generic plastic CR "Style" throttle or the TB billets part # FF0425TB or FF1123TB)

Also the valve kit should be installed by a professional mechanic or shop that offers valve job service as the valve seats must be cut larger to accept the larger valve heads diameters and valves need to be sunk deeper to allow for overlap clearances. The kit includes a document that includes protrusion and installs heights specs.

Also when using TB Parts 132cc piston FF0892TB you must use the supplied thick 1.5mm base gasket UNLESS FF0888TB Big Valve Kit is installed. It helps reduce compression to avoid engine knock.

If you have any questions please call one of our knowledgeable and friendly techs at 833-327-8507